1-2, Introduction 11-28-01 Digital488 User’s Manual
Available Accessories
Additional accessories that can be ordered for the Digital488 include:
CA-7-1 1.5 foot IEEE 488 Cable
CA-7-2 6 foot IEEE 488 Cable
CA-7-3 6 foot shielded IEEE 488 Cable
CA-7-4 6 foot reverse entry IEEE 488 Cable
CA-8-50† 6 foot, 50-conductor ribbon cable with a card edge
connector on one end, the other end un-terminated.
CA-46-40 6 foot digital I/O header connector to ribbon cable for the
Digital488/32/OEM
CN-6-50† 50 Pin solder tab edge connector.
CN-20 Right Angle IEEE 488 adapter, male and female
CN-22 IEEE 488 Multi-tap bus strip, four female connectors in parallel
CN-23 IEEE 488 panel mount feed-through connector, male
and female
Rack488-3† 5-1/4" by 19" rack mount for one Digital488
Rack488-4† 5-1/4" by 19" rack mount for two Digital488s
TR-2† 110 volt Wall mount power supply for the Digital488
TR-2E† 220 volt Wall mount power supply for the Digital488
TR-5 110 volt Wall mount power supply for the Digital488OEM
TR-5E 220 volt Wall mount power supply for the Digital488OEM
†
For use with Digital488 Only
Specifications
Digital488 Specifications
Digital I/O
Terminal Installation Category:
Standard: Not Applicable. CE: Category 1.
Transistor-Transistor Logic (TTL) Levels:
Outputs will drive 2 TTL loads.
Connector:
One 50-pin card edge (mating connector supplied).
To Next Page
Loading...