nanoLTE S60 AP Hardware Installation nanoLTE AP and PSU Regulatory Information
NANO_INST_43315 v200_0.5 for N4G_2.0 © ip.access Limited 2017 Page 16
5 nanoLTE AP and PSU Regulatory Information
This chapter provides the customer with safety and regulatory warnings, cautions and
information for the ip.access Ltd range of products.
• 5.1 Warnings and Cautions
• 5.2 Regulatory Statements for nanoLTE S60 AP
• 5.3 Regulatory Statements for PSAA20R-120L6 PSU
5.1 Warnings and Cautions
Electrical Safety
CAUTION
The nanoLTE AP is intended for dry indoor applications only. If evidence of
condensation is present do not apply power to the nanoLTE AP.
CAUTION
The nanoLTE AP is designed to be operated as a fixed system device and must be
located away from the user. It must be mounted in a manner to ensure that all users
and bystanders are kept a minimum of 20cm away from the integral antennas at all
times.
WARNING
Do not immerse any part of the nanoLTE AP or its power supply in water or any other
liquid. Do not install or use the nanoLTE AP or its power supply near open water. Do
not spill liquids of any type on the nanoLTE AP or its power supply.
WARNING
Do not use liquid, solvent or aerosol cleaning agents on or near the nanoLTE AP or its
power supply.
CAUTION
To avoid the risk of fire and/or electrical shock, do not push objects through openings
into the nanoLTE AP or its power supply. The only exception is the recess for the
Reset switch, which is recessed to prevent accidental operation.
CAUTION
Do not disassemble the nanoLTE AP or its power supply.
CAUTION
The nanoLTE AP must only be powered using the ip.access power supply provided for
use with the nanoLTE AP.
CAUTION
Before using the power supply, verify that the mains voltage is within the range
specified by the voltage printed on the power supply.
CAUTION
The PSU supplied with the nanoLTE AP must not be used for powering any other
equipment.
CAUTION
To avoid the risk of fire and/or electrical shock, do not overload power outlets or
extension cables.