10. Reading and writing
During the reading or writing process (data are being saved on or
read from the virtual floppy) the red Busy LED
lights up. During
this process, do not under any circumstances remove the USB Stick
or deploy the selection buttons
(¶µ).
Please always wait until a read or write process has been
completed, before you continue, or else you may thereby cause
data loss.
11. Safely remove USB Stick from USB Floppy Disk Emulator
Only remove the USB Stick when the Busy LED (red) is not on.
When a read/write process has just been completed, but the LED is
still on for a moment, please wait for a couple of seconds before you
remove the USB Stick.
Also do not remove the USB Stick as long as the two dots are still
visible in the display as here, for example, 03 with dots:
12. Safely remove USB Stick from Computer/PC
Please always remove the USB Stick safely from your computer or
PC. Proceed safely as usual with your operating system (Windows:
safely remove or log out; Linux/Unix: unmount; Mac OS: eject).
Subject to change without prior notice Date: 09-03-10
ipcas GmbH USB Floppy Disk Emulator – USB Floppy v0.2 Page 12 of 17
To Next Page
Loading...