iPECS LIP-9010 - Wall Mount

10 LIP-9000 Series User Guide - ST
1.5.3 Wall Mount
The LIP-9000 series phones can be wall mounted as needed. The following
instructions describe how to perform a wall mount installation.
1. Align the wall-mount bracket (not included) over the back of the phone,
then press the bracket forward applying steady pressure until it clicks
into place.
2. Mark and drill two 7mm holes for plastic wall anchors (not included).
3. Insert the two anchors into the holes and insert and tighten the two
screws (not included) leaving about 2.5 mm (1/8-inch) exposed.
4. Slide the LIP-9000 phone over the screws and assure the phone is
secure.
5. Reverse the handset hook and re-install in the phone so that the hook
catches the groove in the handset receiver,
6. Hang the handset up on the handset hook.
NOTE
It may be necessary to remove the phone and tighten or loosen the screws
for a secure mounting.