34 LIP-9000 Series User Guide - ST
A Flex button on the iPECS Phone assigned as a LOOP button lets you
access a line from a group. Dial codes for access to CO/IP lines are:
Individual CO/IP line access: 88 + Line number
CO/IP Group access: 8 + Group number
Any CO/IP Line access: 9
When dialing on a CO line which uses pulse style signals, you may activate
Dial Pulse to Tone Switchover changing to DTMF style dialing (for
banking services, etc.).
When placing an IP call, you must dial an IP address using the ‘*’ key in
place of the dot.
If Least Cost Routing is set-up, the number you dial will be analyzed and
the system will place the call on the least expensive route.
You may be assigned Dialing and/or CO/IP Line Access Restrictions, in
which case you will receive error tone if you attempt to dial or access a
restricted number/CO/IP line. CO/IP line and Station Class Of Service
(COS), which establish dialing restrictions, may vary during Day and Night
operation (Day/Night COS).
You may need to enter an Authorization code before placing calls, in which
case you will receive a second dial tone.
Your external calls may be subject to Call Time Restrictions, you will
receive a Call Warning Tone prior to disconnect.
NOTE
In the event of an emergency, assigned Emergency numbers (ex., a 911
call) may be dialed from any station in the System, regardless of a Station’s
dialing restrictions (COS).
To place an external call:
Lift the handset,
Dial the CO/IP line/group,
Dial the desired number.
To Next Page
Loading...
