IPS Controllers M920 User Manual

M920 & M920W pH/Dual ORP Controller Owner’s Manual
The provided connecon must allow the remote monitoring module to
access the Internet without providing any usernames, passwords, etc.
via Port 80 for outbound data only.
The best test for this ability is to connect a laptop to the Ethernet
cable and open a web browser. If the browser can open directly to the
web without credenals, the connecon will funcon properly for the
remote monitoring module (laptop Wi-Fi should be turned o when
doing this test).
a. How it works:
The remote module is programmed to “wake up” at a customer
determined interval (minutes) and send all current readings,
sengs, and alerts to the IPS Controllers remote monitoring
website.
Because the data is being sent to the website rather than the
website pulling the data from the module, the port is not le
open and a stac IP Address is not needed. This should address
any concerns regarding rewall security.
When changes are made to the controller sengs remotely,
the new sengs are delivered back to the remote monitoring
module on its next scheduled connecon.
b. Setup - Go to Secon IV-B on Page 30 for installaon
instrucons.
16

IPS Controllers M920 Specifications

General

Brand	IPS Controllers
Model	M920
Category	Controller
Language	English