IPS Controllers M920 User Manual

M920 & M920W pH/Dual ORP Controller Owner’s Manual
D. ConneconRequirementsforRemoteMonitoring
1. IPS-M920W (Wi-Fi)
The remote monitoring module used with the IPS-M920W is a Wi-Fi
device which will access an exisng Wi-Fi network to send controller
data to the central monitoring website.
If an exisng Wi-Fi network is not available, a MiFi or “cellular hotspot”
can be added (contact a local wireless provider).
Note: The Ethernet connector on the M920W is disabled and cannot be
used.
a. How it works:
The remote monitoring module is programmed to “wake
up” at a customer-determined interval (minutes) to send all
current readings, sengs, and alerts to IPS Controllers’ remote
monitoring website.
Because the data is being sent to the website rather than the
website pulling the data from the module, the port is not le
open and a stac IP Address is not needed. This should address
any concerns regarding rewall security.
When changes are made to the controller sengs remotely,
the new sengs are delivered back to the remote monitoring
module on its next scheduled connecon.
b. Setup - Go to Secon IV-A on Page 28 for installaon
instrucons.
2. IPS-M920 (Hardwire)
The remote monitoring module included with the IPS-M920 requires:
• An Ethernet connecon provided by a hard wire directly from a
router,
• A Wi-Fi to Ethernet Adapter,
• Or a Cellular Modem (requires carrier service such as Verizon or
AT&T).
15

IPS Controllers M920 Specifications

General

Brand	IPS Controllers
Model	M920
Category	Controller
Language	English