iRobot Looj - Charging and Installing the Battery

8 iRobot Looj Owner’s Manual
Charging and Installing the Battery
Before you use Looj, charge the
included7.2Vbatteryfor15hours.
Partially used and fully used batteries
shouldalsobechargedfor15hours.
Do not leave Looj’s battery plugged into
the charger for more than several days,
as it may reduce the battery life.
Looj batteries are designed to power
Loojthrough150linearfeetofgutter
on a single charge, including the time
to drive Looj back and forth during
cleaning.
For long term storage, remove the battery
from the robot, fully charge the battery
and store it in a cool, dry place.
To install battery:
1. Depressthetabontheleftsideofthe
battery compartment. Open the door.
2. Connect the battery cord inside the
robot’s battery compartment.
3. Slidethebatteryintothebattery
compartment, wireless end first. Tuck
extrawireintobatterycompartment.
The wire cord will fit on the right side.
4. If used, wipe battery compartment door clean to ensure a
proper seal.
5. Closedooruntilitclicks.