14
-
CONTINUED
SETTING THE SAME WATERING TIME
FOR ALL STATIONS
Use this feature to set the same watering time for all stations using a
single entry. This feature applies to all stations within the same program.
1.
Select the desired program, A or B.
2.
Set the dial to the All Stations Watering Time position.
3.
Press the On A button to increase watering time, the Off
V
button to
decrease watering time.
4.
Press both Advance buttons at the same time to
enter. The
display will
flash to indicate the entry was accepted.
DELETING A PROGRAMMED STATION
To delete a programmed station, set watering time to zero (0)
SELECTING THE DAYS TO WATER
The Dial Series controller has a 14-day watering schedule
(6-day schedule instructions are listed in Advanced Features,
page 21). Table 1 below shows the numbers corresponding to the
days of the week. To program the watering days, refer to table 1
and the steps below.
Table
1.
Watering
Days Schedule
SUN MON TUE WED
THU FRI
SAT
1st Week:
1
2
3
4
5
6
7
2nd Week:
8 9
10
11
12 13
14
-
CONTINUED
1.
Select the desired program, A or B.
2.
Set the dial to the Watering Day Schedule position.
3.
Press the Advance A or Advance
V
buttons until the desired day of
the week is displayed.
4.
Press the On A button to schedule a day on, the Off
V
button to
schedule a day off.
DISPLAYING PROGRAMMED WATERING DAYS
To display the watering days without changing them, do the following:
1.
Select the desired program, A or B.
2.
Set the dial to the Watering Day Schedule position.
3.
Press the Advance A or Advance
V
buttons repeatedly.
The controller displays the days on and days off. For example, the
display “1:ON” indicates Sunday of the first week is a scheduled day
on; “8:OF’ indicates Sunday of 2nd week is not a watering day.
NOTE: OF = OFF.
DELETING A PROGRAMMED
WATERING DAY
If you make a mistake or want to delete a programmed day on, do the
following:
1.
Set the program switch to the program with the day to be deleted,
A or B.
2.
Press the Advance A or Advance
V
buttons until the desired day of
the week is displayed.
3.
Press the Off
V
button to schedule a day off.
4.
Repeat for all watering days to be deleted.
Programming
the Controller for Watering
15
To Next Page
Loading...
Need help?
General
