Why does the level reading on my IS Technologies Measuring Instruments change heavily and periodically?
If the level reading on your IS Technologies Measuring Instruments changes heavily and periodically, it may be due to a motor or alternator being installed. Try setting the velocity lower than the current setting value. Alternatively, move the level to a different position where it is not affected by the machinery.
What to do if the level on my IS Technologies ULM-1000C changes irregularly?
If the level on your IS Technologies Measuring Instruments changes irregularly, it may be due to a barrier within the ultrasonic range. Try setting the velocity lower than the current setting value or set the Detection Threshold Voltage lower than the current voltage. Also, check the sensor's bottom surface for any foreign debris or pollution.
How to fix an incorrect level reading in a sealed space with IS Technologies ULM-1000C?
If the level reading is incorrect in a sealed space when using IS Technologies Measuring Instruments, the pressure may be increased by gas generation. To resolve this, set the sound velocity according to the medium or install ventilation.
What to do if my IS Technologies ULM-1000C level shows only within blanking distance?
If your IS Technologies Measuring Instruments level shows only within the blanking distance, it could be due to protrusions in the nozzle of the reservoir. Check the nozzle's inside surface and the nozzle diameter, ensuring it matches the recommendation in the manual. You can also increase the blanking distance, but not beyond the highest level point.
Installation and operation must be by licensed experts. Always wear protective equipment.
Read manual thoroughly before operating. Manufacturer not responsible for misuse or unauthorized modification.
Follow manual instructions for operation, maintenance, and troubleshooting. Manufacturer not liable for accidents due to non-compliance.
Inspect product and accessories for damage or contamination upon opening the package.
Explanation of caution, warning, and information symbols used in the manual for safety and guidance.
Explains how the ultrasonic sensor works to measure liquid level.
Details measurement range, accuracy, resolution, IP rating, and power requirements.
Lists the items included in the product package, such as the unit, manual CD, and cable gland.
Provides physical dimensions, enclosure material, and protection grade.
Provides general recommendations for proper installation to ensure optimal performance.
Details methods for mounting the ULM-1000C, including using brackets or flanges.
Outlines conditions to avoid, such as flow outlets or direct sunlight, for correct installation.
Shows initial screen and actual level value after power-on.
Details the LCD display modes (Measuring/Programing), fault conditions, and program numbers.
Explains LED indicators and operational modes (Measuring/Programing) for status feedback.
Details the function of each button for navigating menus and changing settings.
Configures measurement mode, units, display, and distance parameters (P01-P04).
Sets 4mA/20mA points, error handling, and fail-safe timers (P05-P09).
Adjusts damping, threshold, output power, sound velocity, and detection (P10-P16).
Tests output simulation and sets the security password for programming (P17-P18).
Details the 3-year warranty period and procedures for repair service.
Addresses issues where the level fluctuates periodically due to external factors.
Resolves problems with inconsistent level readings caused by internal or external interference.
Fixes readings stuck within the blanking distance due to obstructions or nozzle problems.
Solves incorrect readings in sealed spaces, often due to pressure or gas generation.
General| Brand | IS Technologies |
|---|---|
| Model | ULM-1000C |
| Category | Measuring Instruments |
| Language | English |
To Next Page