ISA T 2000 - Page 26

DOC. MIE11110 Rev. 5
Page
26
of
110
WHEN YOU DISCONNECT THE PRIMARY CABLES, PLEASE
CONSIDER THE TEST DURATION. IF IT WAS LONG,
CONNECTION VICE AND CABLE CAN BE VERY HOT: USE
PROTECTION GLOVES!
If, during the test, you have no measurement from the current
booster, this means that you have over-heated the module, and
the thermal protection is intervened, cutting the measurement
output. All you have to do is to wait until the booster is cooled
down, and the measurement comes back.
1.1.3.2 Very high current booster
NOTE: this type of booster is selected setting ON the switch n. 4
of the CONV board PWA21401.
When this test is selected, the following menu is displayed.
ON
1