ISDT T6 - Task Setting; Input;Output BattGo Smart Battery

1:
Connect PSU to charger, wait until charger is in standby then connect your battery to charger.
Short Press ,you will see task setting below:
LiPo-8S
Current
Task
Input Limit
Start
Back
Auto-detect battery type, battery cells
Settings based on BattGo battery's parameter
Select charge/discharge and storage
BattGo battery as input source, input limit could be set to 3.8v/cell or 3.3v/cell
Start task
Back
Input/Output normal battery Input/Output BattGo smart battery
Input/Output BattGo smart battery
Task Setting
Task Settings
Battery Type
Cells Voltage
Cell Count
Currnet
Task
Input Limit
Back
LiPo
4.20V
8S
30.0A
Charge
Task Settings
LiPo-8S
Current
Task
Input Limit
Start
Back
4.20V
30.0A
Charge
3.3V/Cell