Iseki TM3267 - Air-Bleeding Procedure; Throttle Lever

TM3217, 3247, 3267
78
Fuel filter should be replaced by ASSY.
It is impossible to disassemble and maintenance.
Air-bleeding Procedure
NOTE: Normally, further air-bleeding is not required
due to electric fuel pump operating when starter
switch in instrument panel is ON. If engine
will not start after several attempts, check fuel
pump fuses (see Electrical System) and then
proceed as necessary.
CAUTION: Fuel emitted from loosened injec-
tion lines is under high pressure. Keep
hands and face away when the engine is
cranked. Clean all spilled fuel following air-
bleeding procedure.
Throttle Lever
FIG. 144:
The throttle lever should remain in the position
selected by the operator. Through normal use, friction
against the lever may decrease, causing the lever to
move out of the selected position. Turn the adjusting nut
(1) as required to retain the throttle lever in the position
selected.
NOTE: Throttle lever friction adjustment nut is reached
by removing the steering column cover, and
instrument panel.
In case lining is exchanged to parts, apply grease and
assemble is.
1
FIG. 143
FIG. 144