ICP 3020 / ICP 4030 iMC-P Operating instruction
Seite 2
Copyright
isel Germany AG, 2009
All rights reserved.
Despite all care, printing errors and mistakes cannot be excluded.
For suggestions and information on errors, we are grateful.
CE mark for (completed) CNC machinery:
isel CNC machinery are CE compliant and marked accordingly.
For these machines is the CE declaration of conformity valid.
No CE mark for partly completed machinery:
Partly completed machinery (definition from EC machinery directive 2006/42/EC) has no
CE mark.
For partly completed machinery the declaration of incorporation (referred to in Annex II, part
1, section B) is valid.
For all other machinery parts and components, be applied to the CE safety directives, initial
operation are prohibited until all appropriate requirements are met.
The company isel Germany AG assumes no responsibility or liability if you make any
changes without the consent of the manufacturer of the machine that affect the CE-
conformity of the machine.
The EMC test is valid only for the controller’s original configuration ex works, i.e. the
delivery state.
Manufacturer: isel Germany AG
Bürgermeister-Ebert-Straße 40
D-36124 Eichenzell
Tel: (06659) 981-700
Fax: (06659) 981-776
e-mail: automation@isel.com
http://www.isel-germany.com
Item-no.: 970280 BE016
(translation of operation instruction in German language)
State: 02/2014
Technical changes reserved.
Latest operating instructions and manuals for download, visit:
www.isel-data.de/manuals
To Next Page
Loading...
Need help?
General
