Isel ICP 4030 User Manual

ICP 3020 / ICP 4030 iMC-P Operating instruction
page 37
9 Faults
Error
reason
solution
machine will not turn on
net input plug not connected
check net input cable
connection
main switch not switched on
switch on main switch
fuse defect
remove net input plug,
renew fuse
power supply voltage
cannot switch on by
POWER button
hood / door is not closed
close hood / door
Emergency stop switch is
unlocked
unlock Emergency stop
switch
software works not
correctly
main switch not switched on
switch on main switch
power supply for the power
amplifiers not switched on
power amplifiers by
pressing POWER-button
motor cables not connected
check motor cables
no communication via
serial interface
incorrect COM port selected
select correct COM port
incorrect baud rate
select 19200 baud
milling spindle is not
working
incorrect setting in the
spindle module DLL
(only DNC mode)
check settings and change
if applicable
switch on the milling spindle
(only 100-230 V) is switched
OFF
switch on
moving distances of the
axles is incorrect
spindle pitch is not correct in
the software Remote
(in DNC mode)
change spindle pitch in
software Remote/6/
spindle pitch is not correct
set in the initialize section of
user program or in the
programming software
PALPC (in CNC-mode)
change spindle pitch in the
user program or
programming software
PALPC

Isel ICP 4030 Specifications

General

Brand	Isel
Model	ICP 4030
Category	Control Systems
Language	English