35
ISOFLAMES Gas Log Assembly Instructions
Important: Although there is some fl
exibility with
the log placement, adequate spacing
between the logs is NECESSARY
and MUST be maintained for best
performance. Some carbon build
up (sooting) may occur where the
fl ames strike the logs, and should
not be a concern, unless excessive.
If sooting is excessive, rearrange
the top logs to allow more opening
for the fl ame.
CAUTION: Burn hazard! Logs will remain hot
for some time after use.
If you need
to reposition any log to maintain the
proper layout, use heat resistant
gloves or allow logs adequate time
to cool before handling.
Isokern Log Placement Instructions
WARNING: Use only parts specifically approved for
use with this gas log set. Failure to do
so may result in property damage or
personal injury. Check with your local
dealer if you need more information.
This instruction contains suggested log placement for the ISO-FLAMES log set. Some fl exibility is possible in log
placement to suit your individual preference provided excessive sooting does not result from fl ames striking
the logs too directly (see important below). The suggested log placement will allow for superior fl ame pattern
and appearance. Please read these instructions completely and carefully before beginning.
To Next Page
Loading...
