iSpring Water Systems Page 13
E. Install the Tank Ball Valve
NOTE: Do not tamper with the air valve on the lower side of the storage
tank. It has been preset at 8–10 psi by the manufacturer.
1. Unplug the plastic cap on the top of the tank.
2. Wrap the thread three times with plumber’s (Teflon) tape only.
3. Connect the ball valve to the thread. Make sure it is tight, but not overly tight.
4. Place the storage tank in the desired location either horizontally or vertically.
5. Connect the WHITE tubing from the inline filter (5
th
stage) to the tank ball
valve.
(See 5-Stage RO system diagram.)
6. Turn the tank ball valve off.
Off Position
On Position
F. RO Membrane Cartridge Installation
1.) Disconnect the tubing from the fitting as shown in the diagram
below.
To Next Page
Loading...
Need help?
General
