EasyManuals Logo

iStorage datashur User Manual

iStorage datashur
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
#9
www.istorage-uk.com
iStorage datAshur
®
Manual – v 3.1
Note: A double blink indicates the drive is unlocked in Admin mode.
A single blink indicates the drive is unlocked in User mode.
If the datAshur has been reset or hacking detection has been triggered (i.e. no User or Admin PIN exist), the instructions
below can be followed. If a User PIN already exists, the datAshur must be unlocked first with the user PIN by following
instructions under section 5, before an Admin PIN can be created by following instructions below.
User PIN Admin PIN Possible Actions
NOT SET NOT SET
Can set either User or Admin PIN
Cannot access drive until User or Admin PIN
SET NOT SET
Can change User PIN when unlocked as User
Can set Admin PIN when unlocked with User PIN
Can access data when unlocked as User
NOT SET SET
Can set User PIN when drive is locked
Can unlock drive with Admin PIN
Can change Admin PIN when unlocked as Administrator
Can perform Administrator commands
SET SET
Can unlock drive with either User or Admin PIN
Can change User PIN when unlocked as User
Can change Admin PIN when unlocked as Administrator
The following table depicts the possible actions when the drive is in different states:
The drive has to be unlocked in User mode in order to proceed with configuring an Admin PIN.
It is set by following the instructions below:
INSTRUCTIONS LED ACTIVITY
Double press the KEY Button
and
hold on the 2
nd
press for 3 seconds
will double blink once and then turn solid
Enter the New Admin PIN
and press KEY Button
will double blink if correct PIN entry or
will blink alternately if PIN entry incorrect
Re - Enter the New Admin PIN
and press KEY Button
will illuminate together for approximately
2 seconds and then:
will double blink indicating correct PIN entry
Note that at this point the
following occurs:
will double blink if 1
st
and 2
nd
entries match
will blink alternately if PIN entry incorrect
Insert your datAshur into USB port
will illuminate in a constant state
Admin PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
• datAshur must NOT be connected to a host

Other manuals for iStorage datashur

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the iStorage datashur and is the answer not in the manual?

iStorage datashur Specifications

General IconGeneral
InterfaceUSB 3.0 (3.1 Gen 1) Type-A
Read speed195 MB/s
Write speed162 MB/s
SSD capacity240 GB
CertificationFIPS 140-2 Level 3, FIPS Pub 197 Validation, IP58
SSD form factor-
Data transfer rate5 Gbit/s
Password protectionYes
Protection featuresDust resistant, Water resistant
Security algorithms256-bit AES, FIPS 140-2, FIPS 197
InternalNo
Product colorBlack
Housing materialAluminum
Sustainability certificatesRoHS
Form factorSleeve
International Protection (IP) codeIP58
USB version3.2 Gen 1 (3.1 Gen 1)
Device interfaceUSB Type-A
Other operating systems supportedChromeOS
Mobile operating systems supportedAndroid
Keypad number of keys12
Quantity per pack1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth93 mm
Width24.5 mm
Height12.6 mm
Weight46 g
Dimensions (without sleeve) (WxDxH)24.5 x 12.6 x 93 mm

Related product manuals