1. Enter the Admin Mode (UNLOCK + 0 buttons for five seconds. Enter Admin PIN and press UNLOCK).
2. Press and hold UNLOCK + 1 buttons until the LED turns to Solid BLUE and Blinking GREEN.
3. Enter a User PIN and press UNLOCK (a minimum of 7 digits and a maximum of 16 digits).
The LED flashes GREEN three times, then returns to Solid BLUE and Blinking GREEN.
4. Re-enter the new User PIN and press UNLOCK. If the LED stays solid GREEN for two
seconds and then solid BLUE, the User PIN was successfully added.
You can delete ALL User PINs by doing the following:
1. Enter the Admin Mode (UNLOCK + 0 buttons for five seconds. Enter Admin PIN and press UNLOCK).
2. Press and hold 7 + 8 + UNLOCK buttons for five seconds until the LED flashes GREEN three
times and then changes to BLUE / RED alternating.
3. Press and hold 7 + 8 + UNLOCK buttons a second time for five seconds until the LED goes on
solid GREEN for two seconds and then back to solid BLUE, this indicates that the User
PINs were deleted successfully.
You can change the User PIN by doing the following:
1. Unlock the drive by inputting your User PIN and pressing the UNLOCK button.
2. Press and hold UNLOCK + 1 buttons until the LED flashes RED.
3. Enter your current PIN and press UNLOCK.
The LED will be Solid BLUE and Solid GREEN.
4. Enter the new PIN and press UNLOCK (The PIN must be a minimum of 7 digits and
a maximum of 16 digits). The LED will flash GREEN three times, then returns to Solid
BLUE and Blinking GREEN.
5. Re-enter the new User PIN and press UNLOCK. The LED stays solid GREEN
indicating that the User PIN has been changed successfully.
9. Adding a new User PIN
10. Deleting the User PINs
11. Changing the User PIN
To Next Page
Loading...
Need help?
General
