ITech IT-M7723 - Channel:error; Multi-Channel Program Flow

Multi-Channel command(IT-M7723)
Copyright© Itech Electronic Co., Ltd. 73
Note
The detection time of this command takes 1500ms, so the execution of this command
requires a delay of 1.5 seconds. ID refers to the menu Config->Channel Number.
Also see
SYST:REM *OPC *OPC? CHAN:ERR?
CHANnel:ERRor?
This command is used to read the state after CHANnel:LINK is executed.
Syntax
CHANnel:ERRor?
Returns
0: No ID conflict, multi-channel function can be operated normally
1: Slave Master ID Conflict
2: Slave Slave ID Conflict
Note
ID refers to the menu Config->Channel Number. If there is a conflict, please press the
ESC key on the display panel to cancel and manually change the ID.
Also see
CHANnel:LINK
Multi-channel program flow
The operation flowchart of multi-channel program control is as follows.