ITech IT6000C Series User Manual

Power Supply Function
Mode Indicates the power supply working mode. The CV
priority is set to CV, and the CC priority is set to CC.
Step Count The total number of steps, up to 10 million points can
be edited.
Repeat Repeat times, the setting range is 1~65535.
End State
Indicates the end state. Last (the voltage or current
maintained at the last step after the end) or Normal
(return to the normal mode before the List is executed
after the end).
Step Index The sequence number of the single step.
value
Voltage or current value for a single step.
slope Slope for a single step.
Keep Time Pulse width for a single step.
– Sine: Sine wave
The fields included in the .csv template file are explained as follows:
Model
Device model, keep the default settings without
modification.
Firmware
Version
Firmware version number, keep the default settings
without modification.
Serial Number
Device serial number, keep the default settings with-
out modification.
File Type
File type, keep the default settings without
modification.
Waveform Type
Waveform type, keep the default settings without
modification.
Amp Unit Peak-to-peak unit, CV priority is set to V, CC priority
is set to A.
Offset Unit Offset value unit, CV priority is set to V, CC priority is
set to A.
Frequency Unit Frequency unit, Hz.
Mode Indicates the power supply working mode. The CV
priority is set to CV, and the CC priority is set to CC.
Repeat Repeat times, the setting range is 1~65535.
Copyright © Itech Electronic Co., Ltd.
78

ITech IT6000C Series Specifications

General

Brand	ITech
Model	IT6000C Series
Category	Power Supply
Language	English