ITech IT6512D - Voltage Monitoring; Current Monitoring; Resistor Mode

Function and Features
Copyright ©ITECH Electronics Co., Ltd. 36
 Resistor Mode
Pin 23 and Pin 13 ( GND wire) can be connected to a resistor for setting the
output voltage value of the power supply.
To set the 0~5V/0~10V or 0~5KΩ/0~10KΩexternal analog setting range, open
the MENU ( Menu) → CONFIG ( Configure) → Ext-Ctrl ( External Analog
Control).
Press the Right Key to select Voltage( or Resistance).
Press the Right Key to select 5V/10V or 5KΩ/10KΩ within the full scale scope.
Voltage monitoring
This function enables monitoring of voltage output via Pin 24 or the GND pin
( i.e., Pin 13), which can be connected to a digital voltmeter ( DVM). To use this
function, the output control should be under the external analog control mode.
The output voltage monitoring range ( which reflects the power supply output
voltage from zero to full scale) can be selected from 0-10V or 0-5V. To switch on
the monitoring range setting, open the MENU ( Menu) → CONFIG ( Configure)
→ Monitor ( External monitor mode). Press the Right Key to select Voltage( or
Resistance).
Press the Right Key to select the output voltage monitoring range ( 0~10V or
0~5V).
The connection setting of digital voltmeter is shown below.
Current monitoring
This function enables monitoring of current output via Pin 25 or the GND pin
( i.e., Pin 13), which can be connected to a digital voltmeter ( DVM). To use this