ITech IT6900 Series - Environmental and Regulatory Compliance; Environmental Conditions; Regulation Tag

IT6900 User Manual
Copyright ©ITECH Electronic Co., Ltd. iii
 If the equipment is not used in the manner specified by the manufacturer,
its protection may be damaged.
 Always use dry cloth to clean the equipment housing. Do not clean the
inside of the instrument.
 Do not block the air vent of the equipment.
Environmental Conditions
The IT6900 series power supply can only be used indoors or in low
condensation areas. The following table shows general environmental
requirements for this instrument.
Environmental conditions
Requirement
Operating temperature
0°C - 40°C
Operating humidity
20% - 80% (non condensing)
Storage temperature
-20°C - 70 °C
Altitude
Operating up to 2,000 meters
Pollution
Grade 2 pollution
Installation category
Ⅱ
Note
To make accurate measurements, allow the instrument to warm up for 30 min before
operation.
Regulation Tag
The CE tag shows that the product complies with the
provisions of all relevant
European laws (if the year is
shown, it indicates that the year when the design is
approved).
The UKCA tag shows that the product complies with the
provisions of all relevant United Kingdom laws (if the year
is shown, it indicates that the year when the
design is
approved).