ITOH DENKI CBV30 - Introduction

2
CBV30UserManual
1. Introduction
There are some examples of parts that need to be prepared by customers, as
explained within this manual. However, this does not provide any guarantee against
the existence of any rights, such as our industrial property rights, or those of other
companies, in advance.
Notes on industrial
property rights
We respond to technical inquiries based on the contents described within this manual,
and on this product within the range of general items for this product.
There are some descriptions in this manual, about parts, equipment, and wiring
arranged by customers, as well as the controls and operation under such
circumstances. However, these are not included in the guaranteed operating range
and/or support.
Check and/or test by your own risk or your responsibility.
Notes on technical
support
About installation
environment
Disclaimer
Features
Disclaimer
・
A miniaturized design: 129L×34W×21H.
・
Adopted 6-pin D shaped connector for motor cable.
This product is intended for performance level “C”
＊
1
as defined in ISO13849-1
＊
2
.
＊
1: This indicates that even though events that would result in serious injury occur infrequently under
assumed risk environment, there is a high probability to avoid danger if you observe the safety
contents described in this manual.
＊
2: International Organization for Standardization
About the
Performance Level (PL)
of this system
This product is designed as a general industrial device. Do not use for other
applications. We do not take any responsibility for any damage that may result from
the disregarding of these warnings.
In the event that an accident results from the use of this product, we do not
compensate for any damage, including abnormalities of equipment, connection
devices, and/or software, any damage resulting from malfunctions, and/or any other
secondary damage.
Caution : Installation, operation and usage of ITOH DENKI MDRs in combination
with a control card designed by a third party could result in fatal phenomena such
as fire, electric shock, injuries etc which are out of the responsibility of ITOH DENKI.
●
●
●
This product is not equipped with special dust proof/waterproof countermeasures, and
is intended to be used in environments of “Pollution Degree 2”*2, as defined in
IEC60664 -1*1.
＊
1
：
Insulation coordination for equipment within low-voltage supply systems - Part 1 of the International

Standard.
＊
2
：
Non-conductive pollution will occur, but it is assumed that condensation will happen to generate

conductive property temporarily.
In this manual, the driver card model is described as follows: NPN and PNP input
and output models are described separately, when needed.
NPN
CBV30-UL-N CBV30-UL-P
CBV30
PNP
Driver card model
Description
in this manual
About description
of the product
Input and output signals Input and output signals