ITOH DENKI CBV30 - Procedures from Installation to Operation

CBV30UserManual
3
2. Procedures from installation to operation
Procedures from installation to operation
Error
Prepare the 24 VDC power supply, such as
DC power supply units.
Prepare control devices, such as applicable
MDR products or PLC.
Open the package, and check the model,
specifications, and voltage, etc.
Check accessories.
Advance preparation
Start using only after you have understood the product’ s functions,
and safety precautions.
Read this manual
Check Product
Remove root cause of
the error.
（
Maintenance and inspection
）
Make sure switch setting.
Control
Inspect safety before trial run.
Trial run
Starts operation.
Operation
Install the MDR.
Mount the driver card.
Installation
Connect the MDR to driver card.
Connect power and signal cables to driver card.
Wiring
No
Yes
Procedures from
installation to operation
P.11 〜
P.16 〜
P.18 〜
P.20 〜
P.22 〜
P.23 〜
P.25 〜