EasyManuals Logo

ITRON 100G DLS Datalogging User Manual

ITRON 100G DLS Datalogging
78 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
Appendix B Optional sealant application
instructions
In areas where insect intrusion is a problem, Itron recommends an optional sealant to help
keep insects out of the ERT module housing. The Itron-tested and approved sealant (Itron
part number ADH-5106-000) is used to seal gaps in remote ERT module installations that
can allow insect intrusion.
1. Prepare the module for the sealant by verifying
the application area is clean and dry.
Warning: Apply sealant in a well-
ventilated area.
2. Itron recommends sealant application after the
remote module is installed so the cable is in the
installation position. Use the sealant
(ADH-5106-000) to fill the gap.
3. Use enough sealant to fill the gap. Wipe off
any excess sealant and replace the cover on the
sealant tube.
100G Series Gas ERT Module Installation Guide, Remote Mount TDC-0824-017 73
Proprietary and Confidential

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ITRON 100G DLS Datalogging and is the answer not in the manual?

ITRON 100G DLS Datalogging Specifications

General IconGeneral
BrandITRON
Model100G DLS Datalogging
CategoryControl Unit
LanguageEnglish

Related product manuals