Diagraph - an ITW Company PA/4600 & PA/6000 User Manual
User Interface Page 32
User Interface
4.5 Discrete I/O
Map:
Note:
This only applies to units equipped with the optional 6145-405 Discrete I/O Kit
Screen Functionality
Use this menu to map the desired output event to the output port
number. The selection choices are identical for each of the outputs 1
through 6 (Output 1 shown at left). The outputs events will result in
either a toggle of state or a momentary 20 mS pulse, dependent on
event selected. The below table outlines the events, meaning, and
duration of output event:
Output Event Description Output
•
None
Nooutputeventselected None
•
MediaOut
Labeland/orRibbonsupplyisexhausted Steady
•
MediaLow
Labeland/orRibbonsupplyislow Steady
•
Online
Unitisonline(readytoprintandapply) Steady
•
NoFormat
Thereisnoformatintheprintertoprint Steady
•
Error
Unitisoffline,duetoerror.Thisincludes:MediaOut,AirPressure
Out,PrinterErrors,RepeatPrintorTampThresholdExceeded,etc.
Steady
•
Warning
Unit has experienced a condition that requires attention, but it is
stillabletorunonline.
Steady or intermittent,
dependingonevent
•
Cycle
Complete
Theapplycycleisfinished Momentary,20mS
•
CycleStart
Theapplycycleisbeginning Dependent on extension
stroketime
•
LabelPresent
Thelabelisonthetamp Dependentonthe time label
isonthepad
•
LabelReject
Thesystemisrequestingthelabelonthepadtoberejected Dependent on system reject
time
•
RFID/Scan
Good
The system has determined the barcode scan or RFID tag encode
wassuccessful
Momentary,20mS
•
RFID/ScanBad
The system has determined the barcode scan or RFID tag encode
wasunsuccessful
Momentary,20mS
•
RFIDVerify
Thesystemhasverifiedthetagwasencodedproperly,onproduct Momentary,20mS
•
RFIDNo
Verify
Thesystemcouldnotverifythetagonproduct Momentary,20mS
Note:
If no card is installed, all settings must be None for proper operation
To Next Page
Loading...