MONITOR DESCRIPTION
Model 3150-B Operation Manual
10
Controls and Indicators
Basic Keys
When the monitor is plugged into an AC power source the ON switch, when pressed, provides power to
the monitor’s electronic circuits.
The STBY switch, when pressed, disconnects power from the monitor’s electronic circuits.
NOTE: To disconnect the monitor from the main power unplug the AC power cord.
Disables the audible and visual alarms for a two-minute period to allow the operator perform procedures
that would otherwise set off the alarms. This avoids the problem of turning off the alarms and forgetting
to turn them back on. Press this key again to return the alarms to normal before the two minutes have
expired. Pressing ALARM PAUSE key for 3 seconds will turn alarms off. Press ALARMS PAUSE key
again to reactivate the alarms. Pressing ALARM PAUSE key will pause the alarms for 120 seconds (2
minutes).
STBY
ON
ON
ECG
150
HR
I-FILT
60 - 160
REC: DIRECT
18-JUL-2002
11 :40
20 MM/MV
80
I-FILT
REC : D I R EC T
20 MM/MV
11:40
RA LA LL
9K 10k 12k
XRAY O FF
Cardiac Trigger Monitor 3150
PATI EN T I D 8 5 8 7 4 5
PAC E R D E TECT
DISABLED
Programmable
Keys
USB Port
ON switch
(Basic Key)
Alarm Pause
Key
Recorder
Stand By switch
(Basic Key)
ECG Patient
Cable Connector