Ivy Biomedical Systems 7600 User Manual

52 pages

To Next Page

Part No. 2718-55-16

OPERATION MANUAL

Part No. 3232-00-16 Rev.12 EN

Cardiac Trigger Monitor

Model 7600/7800

Model 7800 shown

Default Chapter2
- Table of Contents2
1 User Responsibility4
2 Manual Revision History5
3 Warranty6
4 Introduction7
5 Safety8
- Electrical8
- Explosion9
- Patient Connections9
- Mri10
- Pacemakers10
- Electrosurgery Protection10
- Defibrillation Protection10
- Signal Amplitude10
- Emc10
- Accessories11
- Description of Symbols Used14
6 Monitor Description15
- Intended Use16
- Patient Population16
- Contraindications16
- Classification (in Accordance with ANSI/AAMI ES60601-1:2005)16
- Controls and Indicators17
- Display18
- Alarm Messages18
- Programmable Touch Keys18
- Menu Structure19
- Rear Panel20
- Fuse Ratings20
- Rear Panel Description21
7 Monitor Setup22
- Monitor Installation22
- To Set up the Instrument for Operation22
- Setting the Date and Time23
- Setting the QRS and Alarm Volume23
- Setting the Alarm Limits23
- Setting the Trace Speed23
- Default Settings24
8 Synchronized Output (Trigger)25
- The Synch Pulse25
- Trigger Mark25
- Polarity Lock (P-Lock)25
9 Ecg Monitoring26
- Safety Considerations26
- Patient Connections27
- ECG Electrodes28
- Impedance Measurement (Model 7800 Only)29
- ECG Waveform Amplitude (Size)30
- ECG Notch Filter30
- Lead Selection31
- Low Signal Message32
- Pacemaker32
- Alarm Limits33
10 System Interlock Operation34
- X-Ray Status Messages (Model 7800 Only)34
11 Ecg Data Storage and Transfer35
- ECG Data Transfer Using the USB Port (Model 7800 Only)35
- USB Port35
12 Recorder Operation36
- Changing Paper36
- Recorder Modes37
- Recorder Speed38
- Sample Printouts38
13 Alarm Messages39
- Reminder Signals39
- Patient Alarms39
- Technical Alarms40
- Informatory Messages40
14 Monitor Testing41
- Internal Test41
- ECG Simulator41
15 Troubleshooting43
16 Maintenance and Cleaning44
- The Monitor44
- Patient Cables44
- Preventive Maintenance44
17 Accessories45
18 Disposal46
- WEEE Directive 2012/19/EU46
- Rohs Directive 2011/65/EU46
- Standard of the Electronics Industry of the People's Republic of China SJ/T11363-200646
19 Specifications47

Questions and Answers:

T
Timothy CobbAug 10, 2025
What to do if my Ivy Biomedical Systems 7600 Medical Equipment unit does not turn on?
- E
  Elizabeth EllisonAug 10, 2025
  If your Ivy Biomedical Systems Medical Equipment unit does not turn on, verify that the power cord is properly plugged into both the monitor and the AC outlet. Also, check that the fuses are not blown and that the ON switch is pressed.