What to do if my Ivy Biomedical Systems 7800 unit does not turn on?
If your Ivy Biomedical Systems Medical Equipment unit does not turn on, verify that the power cord is properly plugged into both the monitor and the AC outlet. Also, check that the fuses are not blown and that the ON switch is pressed.
Why is the ECG waveform erratic and the heart rate not counting on my Ivy Biomedical Systems 7800?
If you're experiencing an erratic ECG waveform and the heart rate isn't counting on your Ivy Biomedical Systems Medical Equipment, verify the following: * Ensure the ECG waveform has sufficient amplitude by selecting Lead II or AUTO. * Check the placement of the electrodes, referring to the ECG section for the correct placement diagram. * Confirm that the ECG electrodes have enough conductive gel. * Verify that the measured impedance is less than 50k.
Covers electrical safety for the monitor, including grounding and power connection requirements.
Warns about explosion hazards when using the equipment in the presence of flammable anesthetics.
Details safe practices for connecting patients, including electrical isolation and cable routing.
Provides warnings for pacemaker patients regarding rate meter accuracy and surveillance.
Identifies and explains the function of the monitor's physical buttons and visual indicators.
Describes the information presented on the monitor's LCD screen, including ECG and heart rate.
Lists and explains various technical, patient, and reminder alarm messages.
Details the hierarchical organization of the monitor's menu system for configuration.
Guides the user through the physical setup and mounting of the monitor.
Details the initial steps to connect and power on the monitor for use.
Guides the user on setting high and low heart rate alarm thresholds.
Highlights safety precautions related to ECG lead wires, electrodes, and electrical isolation.
Provides detailed instructions for applying electrodes and connecting patient cables.
Explains the impedance measurement feature for verifying skin preparation and electrode contact.
Explains how to select ECG leads for the trigger and secondary waveforms.
Details the pacemaker detection function and associated warnings.
Instructs on how to set and adjust high and low heart rate alarm limits.
Describes how to save and retrieve ECG data using a USB memory stick.
Details patient alarms such as HR HIGH, HR LOW, and ASYSTOLE.
Describes technical alarms like LEAD OFF, CHECK LEAD, and SYSTEM ERROR.
Guides on performing the monitor's internal self-test for verification.
Explains how to use the integrated ECG simulator for testing.
Lists detailed specifications for the ECG monitoring function.
Lists parameters and levels for various alarm conditions.
General| Category | Patient Monitor |
|---|---|
| ECG | 3/5-lead, arrhythmia detection |
| NIBP | Adult, pediatric, neonatal modes |
| Respiration | Impedance respiration measurement |
| Power | AC power and battery operation |
| Alarms | Audible and visual alarms, adjustable alarm limits |
To Next Page
