Table of Contents
Section 1 - Getting Started 1
Fuel Flow Computer Basics 2
Control Button Basics 2
Display Screen Basics 2
Remote Auxiliary Display Basics 3
RPM and MAP Display Basics 3
Linear Bar Graphs Display Basics 4
LeanFind Basics 5
Section 2 - Interpreting Data 6
Operation for each Phase of Flight 6
Typical Normal Measurements 8
Engine Diagnosis Chart 9
Section 3 - Displays and Controls 12
Control Buttons 12
RPM and MAP Displays 14
Scanner Displays 14
Remote Auxiliary Display 18
Hobbs Display 18
Dimming the Display 18
Section 4 - Operating Modes 19
Manual Mode 20
Section 5 - LeanFind 21
LeanFind Procedure—General Explanation 26
Expanded Leaning Procedures 30
Section 6 - Fuel Flow Operation 31
Fuel Management 31
Start Up Fuel 31
Start Up Fuel 32
Resetting ‘ USED’ 36
Trip Mode (Accumulate Trip Totalizer) 36
Scanner Fuel Flow Display Select 36
Section 7 - Alarms 37
Non-primary Alarm Priority 37
Section 8 - Memory and Data Download 38
Downloading Data from the EDM 38
Transferring data from the USB Flash Drive to a PC 39
To Next Page
Loading...
