For Your Safe Flight Page | 17
The range of the bar graphs depends on the programming. Range,
redlines and/or limits are typically set to match the original aircrafts gauge
markings. These are locked for Primary installations, however non-
primary gauges can be user modified, using the ‘EDM Config’ which is
currently available through the front panel buttons. Editing of Gauge
Layout requires EDM Software version 1.20.489 or later. Note: Amps
can operate either as a charge/discharge or load meter, depending on
programming. For charge/discharge, the center of the bar is zero and the
top and bottom are maximum charge and discharge, respectively.
To Next Page
Loading...
