For Your Safe Flight Page 69
Tap the SELECT key to start repositioning of the gauge on the EDM.
After a gauge is selected, tap the NEXT key to select the new
position for gauge to be moved. When the correct location has been
selected, tap the MOVE key. When all desired gauge location
changes have been made, tap the DONE key to exit this screen. If
you get an extended “Loading…” comment on the display just hit
STEP or NEXT.
Notes: If the EDM is configured as a PRIMARY instrument,
PRIMARY gauges cannot be moved and will be skipped.
The EDM screen must contain at least 2 non-primary gauges in
order to allow repositioning of gauges.
Editing of Gauge Layout requires EDM software version 1.20.464
or later.
5. Removing Fuel Level Gauges from display
If you prefer to use the ship’s fuel level gauges, you can choose to
remove the fuel level gauges from the EDM display. When you see
the EDIT GAUGE LAYOUT? prompt, tap the YES key to allow
selection of the fuel level gauges to be removed from the EDM
screen.
Tap the NEXT key to select the fuel level strip gauge to be removed.
Tap the REMOVE key to remove the fuel level gauge from the EDM.
Both fuel level gauges will be removed.
To Next Page
Loading...
