Show Passphrase/WEP key, on the output screen see the SSID a schematic view of key
Not showing Passphrase/WEP key, on the output screen of a schematic view seen
WPS settings:
You can pass through any of the following methods WPS client simple connection
1. Press the WPS button of the router, and then press the WPS button on the client wireless card and
waiting for connection
2 . The input PIN and the base station waiting for connection
3 . Press the interface <connection> button, then press the WPS button on the wireless card and the client
waits to connect
4. The obtaining the PIN code and inputted in the [connects to the device with a PIN] is column Press
<Connection>and waiting for connection
To Next Page
Loading...