Plasma CUTTER 150
Operating Manual Page 6
4. Technical Data
Plasma CUTTER 150
Supply voltage 3-phase 400 V, 50 Hz
Max. power draw 43 kVA
Fuse 63 A slow
Cutting current 75A /150A
Max. open-circuit voltage 335 V
70 % duty cycle 150 A / 140 V
100 % duty cycle 75 A / 110 V
Max. cutting thickness, quality cut 35 mm
severance cut 45 mm
System of protection IP 22
Insulation class H (180° C)
Type of cooling F
Dimensions L x W x H (mm) 800 x 500 x 800
Weight 165kg
Compressed-air supply 5,5 bar
(depending on torch used) 230 l/min
Authorized for welding under increased electrical hazard
Manufactured in acc. with European Standards EN 60 974-1 und EN 60 974-10
To Next Page
Loading...
