© 2017 Jackson Labs Technologies, Inc. 31
Mini-JLT GNSS™ User Manual
MEASure:VOLTage?
MEASure:CURRent?
MEASure?
3.8.1 MEASure:VOLTage?
This query returns the power supply voltage applied to the OCXO (~10.45V)
3.8.2 MEASure:CURRent?
This command is not supported on the Mini-JLT™ board.
3.8.3 MEASure?
This query returns the result of the two following queries:
MEASure:VOLTage?
MEASure:CURRent?
3.9 SYSTEM Subsystem
This subsystem regroups the commands related to the general configuration of the Mini-JLT™. The
list of the commands supported for this subsystem follows:
SYSTem:COMMunicate:SERial:ECHO <ON | OFF>
SYSTem:COMMunicate:SERial:PROmpt <ON | OFF>
SYSTem:COMMunicate:SERial:BAUD <9600 | 19200 | 38400 | 57600 | 115200>
SYSTem:STATus?
SYSTem:FACToryReset ONCE
3.9.1 SYSTem:COMMunicate
3.9.1.1 SYSTem:COMMunicate:SERial:ECHO
This command enables/disables echo on TTL serial. This command has the following format:
SYSTem:COMMunicate:SERial:ECHO <ON | OFF>
3.9.1.2 SYSTem:COMMunicate:SERial:PROmpt
This command enables/disables the prompt “scpi>” on the SCPI command lines. The prompt must be
enabled when used with the software GPSCon. This command has the following format:
SYSTem:COMMunicate: SERial:PROmpt <ON | OFF>
To Next Page
Loading...