EasyManua.ls Logo

Jacobsen LF 4677 Turbo 67963

Jacobsen LF 4677 Turbo 67963
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 QUALITY OF CUT
56
10.7 STREAKS ________________________________________________________________
NOTE: Arrow indicates direction of travel.
A streak is a line of uncut grass. This is usually caused by
a nicked or bent bedknife.
Probable Cause Remedy
Damaged bedknife. Replace bedknife.
Damaged or unevenly worn reel. Inspect reel. Replace as needed.
Loose or missing bedknife fasteners. Check bedknife screws. Tighten loose screws; replace
missing screws.
Turning too aggressively. Cutting units don’t overlap
around turns or on side hills.
Turn less aggressively to allow cutting units to overlap.
Change mowing direction or pattern on side hills.
Tire mats down grass before it is cut. Check/adjust tire inflation pressure.
Wet grass is matted down before it is cut. Mow when grass is dry.
TN0224

Table of Contents

Related product manuals