Jacuzzi J-470 - Power Requirements for North America

Page 16
J-400
7.0 Power Requirements
Jacuzzi
®
spas are designed to provide optimum performance and
exibility of use when connected to their maximum electrical service.
They are congured at the factory. The most common electrical
connections are listed below:
• All North American 60 Hz Models only: These models come set for
50A logic. If you prefer, your qualied technician can perform a logic
modication that allows the spas to operate on a different electrical
service, see table footnotes below. Reference page 85.
North American Models (60 Hz)
Voltage: 240 VAC/40A* 240 VAC/50A** 240 VAC/60A***
Max. Current Draw:
1-Pump System: 26A 36A N/A
2-Pump System: 26A 37A 48A
3-Pump System: N/A 37A 48A
Frequency: 60 Hz 60 Hz 60 Hz
Number of Wires: 3 3 3
*
In 40A conguration, the heater will not operate while either jets pump is
running. Not recommended for the J495.
**
In 50A conguration, the heater will operate when one jets pump is
running, but will not operate if more than one jets pump is running. This
is the factory setting.
***
In 60A conguration the heater will operate when two jets pumps are
running, but will not operate if three jets pumps is running.