Speaker Bar Replacement
What You will Need:
• Phillip's Head Screw Driver
Caution: *Unplug the sauna before handling any wiring or electrical components*
Step 1: Remove the top cover from the roof by
unscrewing each of the screws around the perimeter
of the roof.
Step 2: Disconnect the speaker wire Molex, which is
connected to the audioboard (red & black wiring). Unscrew
any cable clamps attached to the wiring to release the wiring
harness.
Step 3: Unscrew the base board of the speaker bar to release and remove the speaker bar.
Step 4: Carefully insert the new speaker bar and reinstall the screws. Reconnect the Molex
connector to the audioboard and reinstall any cable clamps. Reinstall the roof cover (make sure
you do not overtighten the screws).
To Next Page
Loading...
