Temperature/Smoke Sensor Replacement
What You will Need:
• Phillip's Head Screw Driver
Caution: *Unplug the sauna before handling any wiring or electrical components*
Step 1: Remove the top cover from the roof by
unscrewing each of the screws around the perimeter
of the roof.
Step 2: Locate the temperature sensor (located on the left side,
above the “hole” in the ceiling inside the sauna). Carefully
disconnect the two wiring connectors from the sensor unit.
Unscrew the two screws from the housing to release the sensor
unit.
Step 3: Carefully put the new unit in place, making sure that the sensor probe is correctly lined
up over the hole. Reinstall both screws and connect both wiring connectors. Reinstall the roof
cover (make sure you do not overtighten the screws).
To Next Page
Loading...
