Jacuzzi JS - LED Strip

LED Strip Replacement
What You will Need:
• Phillip's Head Screw Driver
• Fastcaps
Caution: *Unplug the sauna before handling any wiring or electrical components*
Step 1: To replace the LED strip you must
remove the corresponding heater guard. The
heater guards are attached to the walls of the
Sauna. Behind little round wood fastcaps you
will find the screws to detach the heater guard.
Simply puncture the fastcaps with your
screwdriver, or peel them away to reveal the
screw.
Step 2: Once the heater guard is removed it
will reveal the molex connectors for the LED
strip. Behind the heater guard is a host of
wires, look for the black and red wires and find
the corresponding molex connectors.
Unconnect each molex to free the original LED
strip.
Step 3: The original LED strip may have an
adhesive sticking it to the Sauna, simply peel it
back and remove the original LED strip.
Step 4: Take the new LED strip and re-connect the molex connectors. Make sure the
wires are fished through the proper holes, avoiding any pinched wires. The new LED
strip won't need any new adhesive as it was intended for keeping the original LED strip
in place during transportation.
Step 5: Before screwing back on the heater guard make sure to test the LED light to
make sure it is working. Once the LED is working screw the heater guard back into place
and use the provided fastcaps to cover the visible screw holes.
8