Troubleshooting
Problem
4. No water flow from jets.
5. Noisy pump and motor.
6. Water leakage at pump
shaft (rotating connection
between pump and motor).
7. Motor will not start.
Probable Cause
A. Power turned OFF.
B. Pump OFF.
C. Motor(s) not connected.
D. House circuit breaker
tripped; no power to system.
E. GFCI tripped.
F. Faulty pump or motor.
A. Clogged suction cover(s).
B. Leakage of air into suction
line.
C. Vibrating parts attached to
motor or support brackets.
D. Low water level.
E. Damaged or worn motor
bearings.
F. Impeller rubbing inside case.
G. Debris inside pump.
A. Worn or damaged pump
seal.
A. Power OFF.
B. House circuit breaker
tripped or in OFF position.
C. GFCI tripped.
D. Subnormal voltage.
E. Improper or defective wiring.
F. Locked shaft or impeller.
G. Motor windings burned out.
H. Defective starting switch
inside motor.
Remedy
A. Turn ON power at the
service panel.
B. Press jets button.
C. Check motor plug
connections on electrical
cabinet.
D. Reset circuit breaker.
E. Reset GFCI.
F. *
A. Clean suction covers.
B. Locate and repair leaks.
C. Tighten fasteners.
D. Add water to normal level.
E. *
F. *
G. *
A. *
A. Turn ON power at the
service panel.
B. Reset circuit breaker.
C. Reset GFCI.
D. Call a qualified electrician
or your power company.
E. *
F. *
G. *
H. *
*NOTE:The skills and tools necessary for the safe repair of this hot tub require the services of
qualified personnel. Contact your Jacuzzi Premium Spas dealer or service organization.
Page 41
To Next Page
Loading...
