10
u Hi/Low setting
Press key, then press key, the LCD display shows
, press key to move the blinking “0”,press
key to enter the limit of the HI weighing value . Press
key after that, the LCD display shows , press
key to move the blinking “0”, press key to enter the limit
of the LO weighing value Press key again, the Hi, Low setting
are completed and ready for operation. The value of Low must be set
lower then the value of Hi.
Press to cancel Hi/Lo check function.
Remark:
◎ When
setting is set to “ON”, the Hi/Low values will
be saved in the memory and can be recalled whenever the scale is
on.
◎ The and keys are applicable when operation.
To Next Page
Loading...
Need help?
General
