INTERIOR
AND
FURNISHINGS
The materials used inside your
motor
home have
been
selected
for
durability
and
comfort.
With
reasonable care, these materials
will
stand up under
years
of
recreational living. The MAINTENANCE
SECTION
in
this
manual outlines care requirements
for
the
various upholstery fabrics, floor, cabinet, and
wall finishes.
STORAGE
Storage facilities in your
motor
home have been
designed
to
remain secure
while
the
vehicle is in
motion.
Exterior compartmen"ts have key-operated
locks. (The
LP
gas
compartment
is required by fire-
prevention regulations
to
be
unlocked
at
all times.)
Interior drawers rest in small notches or detents when
closed;
to
open,
lift
slightly
to
clear
the
detent, then
pull open. When storing articles:
• Always keep tools and equipment stored in areas
where
they
will
not
shift
while
traveling.
•
Whenever possible, place heavy articles in
storage
compartments
which
are
low
and near
the
axles
for
better
weight
distribution.
• Pack
articles
carefully
in
the
storage
compartments
to
minimize shifting.
If
necessary,
use straps
to
prevent movement.
•
Be
sure liquid containers are capped and cannot
tip
or spill. Secure all glass containers and dishes
before
traveling.
• Secure all
free standing furniture.
•
~xterior
storage
compartments
may
not
be
water-tight
in all
climate
conditions. Carry any
articles
which
could
be
damaged by water inside
the
motor
home.
Some models may be equipped
with
slide-out
luggage
compartments. A capacity rating tag attached
to
the
compartment
specifies
the
maximum
weight
load
the
compartment
is designed
to
carry.
Be
sure
to
keep
the
load
below
or
at
this
limit.
Clean
and
lubricate
the
compartment
slides
periodically
with"light
oil
or
spray lubricant.
Close
and
lock
the
compartments
while
traveling.
WARNING: OUTSIDE STORAGE COMPARTMENTS
ARE
NOT SEALED, VENTED ENCLOSURES, AND
ARE
ACCESSIBLE FROM INSIDE THE MOTOR HOME. DO
NOT
STORE
FLAMMABLE,
VOLATILE LIQUIDS,
HAZARDOUS CHEMICALS
OR
EQUIPMENT
IN
THESE
AREAS.
14
DINETTE CONVERSION
To
convert
the
dinette into a bed:
• Unsnap cushions.
• Reach under
the
table, release leg latch and fold
leg
back.
• Raise
front
portion
of
table several inches
to
disengage inserts
from
the
wall supports.
• Lower table
top
into position
to
complete bed
base.
• Slide seat and back cushion
into
place over bed
base.
The under-seat storage may be reached
by
raising
the
cushion frame or, on some models,
through
the
door
at
the
end
of
the
seat.
To Next Page
Loading...
