- 26 -
G31 Series User's Manual
►
APM Conguration
This item allows you to set Power Management/APM between Enable or disable, Power
down video in suspend or standy Mode, Power down hard disk in suspend or standby
mode, Go into suspend in the specied time, Select the Duty Cycle in Throttle mode,
Monitor KBC ports 60/6 and go into On/Off, or suspend when power button is pressed.
►
ACPI Conguration
This item allows you to select ACPI Suspend Type (S3 mode is optional ) and allows
you to set or Enabled / Disabled the Advanced conguration.
4.5.9 BIOS Secturity Features
CMOS Setup Utility - Copyright (C) 1985-2004,American Megatrends, Inc.
BIOS Secturity Features
Security Settings
Supervisor Password : Not
User Password : Not
Change Supervisor Password
Change User Password
Installed
Installed
[Press Enter ]
[Press Enter ]
Item Help
Install or Change the
password.
↑↓
→←
:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F7: Previous Values F8: Fail-Safe Defaults F9: Optimized Defaults
Press Enter
When Chage Supervisor/User Password function is selected, the following message
appears at the center of the screen to assist you in creating a password.
Enter New Password:
Type the password, up to eight characters, and press <Enter>. The password typed now
will clear any previously entered password from CMOS memory. You will be asked to
conrm the password. Type the password again and press <Enter>.
Note:
Don’t forget your password. If you forget the password, you will have to
open the computer case and clear all information in the CMOS before you can start
up the system. But by doing this, you will have to reset all previously set options.
You may also press <Esc> to abort the selection.
Enter New Password:
To Next Page
Loading...
Need help?
General
