- 34 -
G31 Series User's Manual
4E Manufacturing POST Reboot if Manufacturing POST Loop pin is set. Otherwise
Loop or Display display any messages (i.e., any non-fatal errors that were
Messages detected during POST) and enter Setup.
4F Security Check Ask password security (optional).
50 Write CMOS Write all CMOS values back to RAM and clear screen.
51 Pre-boot Enable Enable parity checker.
Enable NMI, Enable cache before boot.
52 Initialize Option ROMs Initialize any option ROMs present from C8000h to EFFFFh.
NOTE: When FSCAN option is enabled, ROMs initialize from
C8000h to F7FFFh.
53 Initialize Time Value Initialize time value in 40h: BIOS area.
60 Setup Virus Protect Setup virus protect according to Setup.
61 Set Boot Speed Set system speed for boot
62 Setup NumLock Setup NumLock status according to Setup.
63 Boot Attempt Set low stack Boot via INT 19h.
B0 Spurious If interrupt occurs in protected mode.
B1 Unclaimed NMI If unmasked NMI occurs, display.
Press F1 to disable NMI, F2 reboot.
E1-EF Setup Pages E1- Page 1, E2 - Page 2, etc.
FF Boot
To Previous Page
Loading...
Need help?
General
