EasyManuals Logo
Home>Jandy>Water Pump>VS PlusHP

Jandy VS PlusHP User Manual

Jandy VS PlusHP
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Page 3
ENGLISH
Jandy
®
Pro Series VS PlusHP Pumps
|
Installation & Operation Manual
Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
1.1 Safety Instructions
All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
WARNING
To reduce the risk of injury, do not permit children to use this product.
WARNING
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide, or full
ow)valvepositionwiththepumprunning.
WARNING
Jandy Pro Series pumps are powered by a high voltage electric motor and must be installed by a licensed or
certiedelectricianoraqualiedswimmingpoolservicetechnician.
WARNING
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Connect only to a branch circuit that is
protectedbyaground-faultcircuit-interrupter(GFCI).Contactaqualiedelectricianifyoucannotverifythatthe
circuit is protected by a GFCI. A GFCI should be provided by the installer and should be tested on a routine basis.
To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should
be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to
thepumpwithoutthetestbuttonbeingpushed,agroundcurrentisowing,indicatingthepossibilityofelectrical
shock.Donotusethepump.Disconnectthepumpandhavetheproblemcorrectedbyaqualiedservice
representative before using.
Duetothepotentialriskofre,electricshock,orinjuriestopersons,ZodiacPumpsmustbeinstalled
in accordance with the National Electrical Code
®
(NEC
®
),alllocalelectricalandsafetycodes,andthe
Occupational Safety and Health Act (OSHA
®
).CopiesoftheNECmaybeorderedfromtheNational
Fire Protection Association (NFPA
®
)onlineatwww.nfpa.orgorcall617-770-3000,orcontactyourlocal
government inspection agency.
InCanada,ZodiacPumpsmustbeinstalledinaccordancewiththeCanadianElectricalCode(CEC).
WARNING
Incorrectlyinstalledequipmentmayfail,causingsevereinjuryorpropertydamage.
WARNING
Do not connect the system to an unregulated city water system or other external source of pressurized water
producing pressures greater than 35 PSI.
Trappedairinsystemcancausethelterlidtobeblownoff,whichcanresultindeath,seriouspersonalinjury,
or property damage. Be sure all air is out of the system before operating.
WARNING
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED, CAN RESULT IN SERIOUS INJURY
OR DEATH. Do not block pump suction as this can cause severe injury or death. Do not use this pump for wading
pools, shallow pools or spas containing bottom drains, unless the pump is connected to at least two functioning
suctionoutlets.Suctionoutlet(drain)assemblies and covers must be certified to the latest published version of
ANSI
®
/ASME
®
A112.19.8, or its successor standard, ANSI/APSP-16.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jandy VS PlusHP and is the answer not in the manual?

Jandy VS PlusHP Specifications

General IconGeneral
BrandJandy
ModelVS PlusHP
CategoryWater Pump
LanguageEnglish

Related product manuals