14
•Insertingthebobbin
z Place a bobbin in the bobbin holder w with the
thread running off counterclockwise.
q End of thread
w Bobbin holder
x Guide the thread into the first notch e on the front
side of the bobbin holder.
e Notch
c Draw the thread to the left, sliding it between the
tension spring blades.
v Continue to draw the thread lightly until the thread
slips into the second notch r. Pull out about 4˝ (10
cm) of thread.
r Notch
b Attach the hook cover plate. Check the threading
by referring to the diagram t shown on the hook
cover plate.
t Threading diagram
y End of thread
z
x
c
v
b
q
e
r
t
w
y
To Next Page
Loading...
