12
Inserting the bobbin
z Press the lockout key. Place the bobbin in the bobbin
holder with the thread running off counterclockwise.
q Lockout key
x Guide the thread into the front notch on the bobbin
holder.
w Front notch
c Draw the thread to the left, sliding it between the
tension spring blades.
e Tension spring blades
v Continue to draw the thread gently until the thread
slips into the side notch.
r Side notch
b Pull out about 10 cm (4”) of thread to the rear.
Reattach the hook cover plate.
Press the lockout key to unlock the machine.
t Hook cover
NOTE:
The threading chart is shown on the hook cover for your
reference.
z
r
x
c
v
b
e
w
t
q
To Next Page
Loading...
