EasyManua.ls Logo

Janome Horizon Memory Craft 12000 - Needle and Presser Foot Management; Replacing Needles

Janome Horizon Memory Craft 12000
151 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
JanomeFlyer.com
16
Replacing Needles
CAUTION:
Always make sure to press the lockout key to lockout the
machine or turn the power switch off before replacing the
needle.
Raise the needle by pressing the needle up/down button.
Press the lockout key.
q Lockout key
Loosen the needle clamp screw by turning it counter-
clockwise.
Remove the needle from the clamp.
w Needle clamp screw
Insert a new needle into the needle clamp with the flat
side of the needle to the rear.
e Flat side
When inserting the needle into the needle clamp, push it
up against the stopper pin and tighten the needle clamp
screw firmly with a screwdriver.
To check needle straightness, place the flat side of the
needle onto something flat (a needle plate, glass etc.)
The gap between the needle and the flat surface should
be consistent.
r Gap
Never use a blunt needle.
r
e
q
w
Fine
Medium
Silk #80-100
Cotton #80-100
Synthetic #80-100
Heavy weight
Denim
Tweed
Coating
Quilting
Lawn
Georgette
Tricot
Sheeting
Jersey
Wool
Knit
#9/65-11/75
Blue needle
Thread Needle
Silk #50
Cotton #50-80
Synthetic #50-80
#11/75-14/90
Red needle
Silk #30-50
Cotton #40-50
Synthetic #40-50
#14/90-16/100
Purple needle
Fabric and Needle Chart
For general sewing, use needle size
#11/75 or #14/90.
Fine threads and needles should be used
for sewing fine fabrics.
In general, use the same thread for both
needle and bobbin.
Use a blue needle for sewing fine fabrics,
stretch fabrics and buttonholes to prevent
skipped stitches.
Use a purple needle for sewing thick
fabrics, denims and across the hem to
prevent skipped stitches.
Use a stabilizer or interface to stretch or
fine fabrics to prevent seam puckering.
Always test the thread and needle size on
a small piece of the same fabric you will
use for actual sewing.
For embroidery:
In general, use a blue needle
Use a red needle for dense stitch embroidery.
Janome bobbin thread for embroidery is
recommended for bobbin.
Fabric
NOTE:
1 x twin needle, 2 x blue needle (#11/75), 1 x red
needle (#14/90) and 1 x purple needle (#14/90) are
included in the needle case.
Janome 12000 Sewing Machine Instruction Manual
www.janomeflyer.com
12000 Owners Manual/ User Guide

Table of Contents

Related product manuals